v1.9.4.57

These releases originated from the base master branch 1.3.4.52 of pascallanger/DIY-Multiprotocol-TX-Module

What's Changed

1. Adds the (Eachine) Ao-Sen-Ma / CG022 Protocol:
   This protocol requires the addition of the CG022 LT8910 RF Board harvested from the original models transmitter.
   It can be installed inside the MPM's external case via six wires to the breakout pins found on the iR4X or Jumper external MPM
   plus an additional wire connection between RET on LT8910 and pin 37 (PA14) on the STM32 MCU.
   More details: Hardware Setup

2. Three LT8910 / CG022 AIR builds available in this release for the serial STM32 128KB module versions:
   Example of the available builds naming (mm-stm-ser-lt8910-[order]-air-v1.9.4.57)
   CFLIE Protocol was removed from these three AIR build to allow space for this new CG022 Protocol.
   The CG022 code can be compiled for others by un-commenting the #define LT8910_INSTALLED under RF CHIPS section in _Config.h

3. All MULTI_AIR 128Kb Release Builds:
   The NCC1701 Protocol has been removed from all "air" builds to allow space needed for this release build.
   If this protocol is required you will need to compile your own version from source code within this release.

4. Changed the Minor Version Number to "9": for releases in this forked repo I have adopted this format for easy identification.
   These releases will follow this format (currently 1.9.4.57)

Full Changelog: 1.9.4.56...1.9.4.57

Disclaimer: This firmware has been tested, but it is provided 'as is' without any warranties. You are strictly warned that you use it entirely at your own risk. I am not responsible for any damage that may occur to to others, yourself or your model.