FES

FES Medel problem solving

---

KT Motion Guide

1. Connect the individual electrode cables to the main cable and the main cable to the stimulation device.
2. Connect the cables to the electrodes and stick the electrodes to the skin.
3. Switch on the device
4. Select the custom program named EmgStim.
5. Open the emgReading.ino sketch in the Arduino IDE and upload it.
6. Open MATLAB and execute the script emgRecording.m.
7. Once recording is complete, close the MATLAB figure window and save the matrix variable from the workspace.
8. Ensure the device is switched off prior to removing electrodes or cabling. Gently peel electrodes from the skin without pulling directly on the lead wires, and store them on the protective backing foil. Disconnect cables from the device by pulling on the connector plugs rather than the cables.

Sensors Position

Title3

fill here