Tips for Redux and the Mosfet Party ps_on adapter - for FSP500

[meeeearcus]

Appreciate all the work that’s gone into this project. I didn’t find this asked before, so apologies if it was covered.

I’m attempting to attach the ps_on pcb/adapter with the recommended m3 screws and I’m curious how others have found success. I have the power source loose, tried securing the pcb, but am struggling with the tight angles and only a tiny L-shaped wrench for the M3s. Cables attached before fastening or attach them after? Any special tools that help?

I have a 10-pin extension already and a fan extension on the way. I also have the microfit adapter with the orange clip from mosfet party this makes for an additional challenge with one of the fan ports on the ps_adapter.

thanks for any guidance!

[NexGen-3D-Printing]

Yes, throw that tool in the trash, they are useless tools, I own and use these:

• LTT screwdriver
• DeWalt Gyro control electric screw driver with Le Bear Hex Bit Set
• Drone Too Kit: https://www.amazon.com/Aluminum-Hexagon-Screwdriver-traxxas-Helicopter/dp/B09NYG3D7X
• Xiaomi Electric Precision Screwdriver: https://www.amazon.com/Xiaomi-Precision-Screwdriver-Rechargeable-Screwdriving/dp/B09KY4ZZXP

The third option is cheap, and an absolute requirement for any hobby DIY stuff, 2mm and 2.5mm being the most used for any of these projects.

Trying to fumble around with those "freebie" allen kyes is like trying to play pick up sticks with your butt cheaps :)

[meeeearcus]

Thanks @NexGen-3D-Printing, I’ll mull over those and appreciate the budget option. I think the fan extender will help with the mounting struggles. If I find any useful techniques, other than not trying to caveman it, I’ll report back.

[NexGen-3D-Printing]

I use a fan splitter cable, the second fan header I use to connect to the Mosfet board for the Host_On, but this will only work with FSP500, if you are using any other PSU, you have to use the TPM header, as the Fan output has issues: mosfetparty/bc250-psu-adapter#1 (comment)

I just use the TPM header now for all, and you will need to solder the BTN Out to the underside of the PCB if you want full functionality, if you search around in here, I have posted some pics and instructions.