Display isn't working?

[bobsyouruncleswife]

After the latest updates, my display is stuck. Is there something I missed in configuration? It only goes to Printer Info on bootup and doesn't have the correct info. What do I need to do? Do I need to go back a version of Klipper or the display firmware?

[halfmanbear]

Re-install Touchscreen Display Service:

• SSH to printer as user mks

  ssh mks@YourPrintersIP
  

• run the command

   opennept4une
  

• Select 5) Install/Update Touch-Screen Service (BETA)
• Press y at the first prompt
• Check on your touchscreen itself, in Settings > About Machine > UI Version for the version number
• Ensure your touch-screen is on the latest Elegoo firmware, ideally ≥ UI v1.2.14(if not see instructions below)
• Reboot your printer with;

  sudo reboot
  

[bobsyouruncleswife]

Thank you so much! I'll give that a shot now.

[uurf]

When I attempted to do this I saw a lot of permission denied fly by and I don't think it succeeded

[uurf]

And now I'm getting these warnings:

[update_manager]: Failed to load extension display: Invalid path for option `requirements` in section [update_manager display]: Path `/home/mks/display_connector/requirements.txt` does not exist
Unparsed config option 'primary_branch: ' detected in section [update_manager display]. This may be an option no longer available or could be the result of a module that failed to load. In the future this will result in a startup error.
Unparsed config option 'origin: https://github.com/OpenNeptune3D/display_connector.git' detected in section [update_manager display]. This may be an option no longer available or could be the result of a module that failed to load. In the future this will result in a startup error.```

[uurf]

also
Could not determine the current branch for /home/mks/display_connector!

[bobsyouruncleswife]

That worked! Thank you so much!

[bobsyouruncleswife]

FWIW, it seems to get stuck on the Printer Information screen and you can't escape it. Could this be a touch-screen firmware issue?

[bobsyouruncleswife]

Nevermind... mine is on 1.2.16. :)