Home

Welcome to the OpenNept4une Wiki!

Getting Started with OpenNept4une

Table of Contents

• Prerequisites
• Flashing OpenNept4une
• Initial Configurations & Updates
• Post-Installation Setup
• Importing OrcaSlicer Profiles
• Klipper & OrcaSlicer Printer Calibration

---

Prerequisites

• For N4 or N4Pro users, determine your Stepper & PCB Version first.
• Acquire an eMMC to USB Adapter: MKS USB3 Adapter - AliExpress or Adapter with spare eMMC - AliExpress.
• Connect the printer via Ethernet and note the IP address.
• Power off the printer and access the Mainboard via the underside panel, then safely remove the eMMC module.
• If your printer lacks an externally accessible microSD slot (located on the front I/O panel to the left of the USB-C port)
  follow these instructions: Hidden microSD Access.

---

Flashing OpenNept4une

Download and Preparation:

• Download the latest OpenNept4une Image suitable for your printer model.
• Use balenaEtcher to flash the image onto the eMMC.

Installation:

• Reinsert the eMMC into the mainboard.
• If the printer has an externally accessible microSD slot, reattach the printer's access panel.
• Power on the printer and connect via SSH using: ssh mks@YOUR-PRINTERS-IP. Password: makerbase.

---

Initial Configurations & Updates

• Execute the Kiauh script with:
  ~/kiauh/kiauh.sh
• Select menu Option 2, update all programs, then exit kiauh.
• Update and run the OpenNept4une script:
  cd ~/OpenNept4une/ && git fetch --all && git reset --hard origin/main && git clean -fd
  Followed by
  ~/OpenNept4une/OpenNept4une.sh
  Select Option (1) to install the latest printer configurations and accept updates to other configurations as prompted

Update Klipper MCUs:

• After a reboot run
  opennept4une
• Select Option (4) to update ALL MCUs. (Skip the Pico update when prompted)
• Follow the instructions within the script to complete

---

Post-Installation Setup

Configure WiFi & Install the display (Touchscreen):

• To configure WiFi / to install the touch-screen service, re-run;
  opennept4une
• Select Option (2) in the OpenNept4une menu for WiFi and Option (5) for touchscreen install

Timezone Configuration:

• Set the correct timezone through Armbian configuration:
  sudo armbian-config
  Then navigate to Personal > Timezone.

---

Importing OrcaSlicer Profiles

• Download & install the latest Official Release OrcaSlicer
• Configure your Printer Model in Orca with 0.4mm nozzle and PLA default presets
• Check / Confirm Bambu Network Engine install
• Download the latest OrcaSlicer Profiles
• In OrcaSlicer click [File > Import > Import Configs...]
• Within each of the three dropdown menus on the left for Printer, Filament & Process select the OpenNept4une User preset
• Click the WiFi symbol to the right of the Printer preset dropdown, enter your printer's IP to enable network gcode upload

---

Klipper & OrcaSlicer Printer Calibration

Here

---