Guide to Building the MagicPhoenix Kit - Differing from Voron 2.4 Manual

Disclaimer: This guide is based on my personal experience and understanding of the build process. I am not responsible for any damage, errors, or issues that may arise during the construction. Please proceed with caution and refer to official sources for additional guidance.

Shoutout: A big thank you to @Livezxy, the owner of MagicPhoenix, for providing this exceptional kit and making this guide possible. Your dedication is appreciated!

Note: This guide provides instructions specific to the MagicPhoenix kit. For general steps, please refer to the Voron 2.4 manual.

Page 54: Cutting the Magnetic Pad

• The magnetic pad is larger than the aluminum plate. Trim it so screw heads are exposed and edges are neat using a razor blade. For video guidance, follow Nero's guide.

Pages 55-57: Installing Buildplate Thermistor

• The kit comes with a pre-assembled buildplate. Install the secondary buildplate thermistor (NTC100K B3950) into the screw hole to the right of the thermal fuse. (This is your Buildplate Thermistor.)

Page 84: Cable Chains (Skip)

• Skip cable chain installation for X/Y axes. MagicPhoenix kit utilizes CAN-Bus.

Page 106: X-Endstop Installation

• Install all four screws on both sides. The X-Endstop is on the toolhead; no need for later installation.

---

ChaoticLab CNC Tap Usage:

Page 129: Installing CNC Tap

• Leave some slack in the belt for trimming later. Follow the ChaoticLab CNC Tap guide up to page 5.

Pages 139-141: Skip

• Belt clamps are integrated into ChaoticLab CNC Tap.

Pages 143-145: Skip

• MagicPhoenix kit uses Tap, there is no need for an inductive probe.

---

Page 146: ClockWork2 & Stealthburner Manual

• Follow the ClockWork2 & Stealthburner manual.
• Before installation, ensure flashing of M8P and Toolhead PCB via this guide.
• Install CAN as guided in BTT Guide.

Page 148 (Electronics):

• Refer to the Voron Manual only for screw sizes. Follow the mpx wiki for wiring guidance.

Pages 150-152: Skip

• BTT CB1 on M8P replaces these components.

Pages 158-165: Skip

• MagicPhoenix uses Tap, there is no need for a dedicated Z-Endstop.

Pages 169-200: Skip

• Follow the mpx wiki for wiring guidance.

Page 204: Umbilical Cable Routing

• Skip until P210. For cable routing, consult the umbilical guide. (You will have to split open the black CAN wire sleeve in order to make all the necessary connections in the electronics bay.)

Page 231: Fan Connections

• Use the image on the mpx wiki to connect fans.

Pages 250-256: Exhaust Customization

• Skip these pages. Utilize a custom exhaust design resembling this example.