Could not create zynqmp_fsbl application for the given hw design | Details: FSBL uses these IPs but are missing in the design: psu_i2c_0

[HankIC]

Hello! I follow the instructions in "https://github.com/Xilinx/Vitis-Tutorials/tree/2021.2/Vitis_Platform_Creation/Introduction/02-Edge-AI-ZCU104" and change some board information to ZCU106 in step1 and step2. In the end, this problem happens, how can I fix this problem in makefile or tcl?
error_in_terminal.txt

[allyzhou]

Have you tried on a newer version of Vitis? for example 2022.1

[sven2314]

Hi @HankIC,
I checked the zcu106 board's schematic. The I2C0 is used to do power related control. So enabling the I2C0 in Vivado design is required.
Please add I2C0 support in system-step1.tcl file like the following 'set property' line is the code. Other lines are to point the location.

# Create address segments
  assign_bd_address -offset 0x80000000 -range 0x00010000 -target_address_space [get_bd_addr_spaces zynq_ultra_ps_e_0/Data] [get_bd_addr_segs axi_intc_0/S_AXI/Reg] -force
  set_property -dict [list CONFIG.PSU__I2C0__PERIPHERAL__ENABLE {1} CONFIG.PSU__I2C0__PERIPHERAL__IO {MIO 14 .. 15}] [get_bd_cells zynq_ultra_ps_e_0]
  # Restore current instance
  current_bd_instance $oldCurInst

You can also enable the I2C0 support in Vivado GUI. Just double click the Zynq UltraScale+ MPSoC IP and go to IO configuration, then enable the I2C0 and set the PIN group to MIO 14, 15.
After that you will not encounter that issue.

[HankIC]

Have you tried on a newer version of Vitis? for example 2022.1

Hello @allyzhou , its difficult for me to change a new version because VITIS installer is so big(near 100G!) and Ubuntu network is not good enough. It may cost me several days to download a installer from website to windows PC and upload the installer to baiduyuncloud and download the installer from baiduyuncloud to ubuntu T-T. Last but not least, I have to download new version petalinux, sstate cache again(near 100G!)

[HankIC]

Hello @sven2314 , thank you for your advise! I haven't got new result up to now because I have run step2 many times this evening. Step2 always gets stuck in not fixed point and stops for a long time. As a result there is no new progress. So I have to kill the process and run step2 again. Now step2 stops again! it has been stuck here for 26 minutes!
(I use ubuntu 18.04.02. Vitis and petalinux version is 2021.2)

---

New update: I close network sstate link (y->n) and petalinux is forced to use files in aarch64. Petalinux can compile smoothly. But my disk is out of space! only 1G left and the process is forced to stop. It may take me another day to reinstall ubuntu and Vitis and petalinux.

[HankIC]

Hello @sven2314, thank you! the problem disappeared!!!!
@allyzhou @sven2314 thank you very much!