Revert "dts: fmcmotcon2: Switch from Cadence to Xilinx Ethernet driver" #720
Conversation
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
This reverts commit aeaf4db. Which was done via PR #117 For Talise SOM we have a similar situation, where GEM0 has 2 PHYs on the same MDIO bus. And GEM1 needs to use one of the PHYs which are attached to GEM0. The situation was resolved for that board. We just need to test that the same solution works for this board + setup. Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com>
|
@dbogdan |
|
It seems that ethernet ports are not available without this patch-revert. The motor control project has been removed from the HDL repo in master. |
dbogdan
approved these changes
Dec 16, 2019
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
This reverts commit aeaf4db.
Which was done via PR #117
For Talise SOM we have a similar situation, where GEM0 has 2 PHYs on the
same MDIO bus. And GEM1 needs to use one of the PHYs which are attached to
GEM0.
The situation was resolved for that board.
We just need to test that the same solution works for this board + setup.
Signed-off-by: Alexandru Ardelean alexandru.ardelean@analog.com