Repository navigation
|
my new Athom Dual Plug V3 with tasmota 15.6.0 stops showing/recording power consumpion (chip BL0939). 13:18:50.774 BL9: Rx 558D0B00000000000000BACA3B270400000000000000000000A80000980200FE030090 Any help is apriciated |
Replies: 5 comments 7 replies
|
What happens if you remove power from the unit, wait a minute and then reapply power? |
|
I have seen remove power from the unit has solved the issue in the past for some hours. |
|
The programmer of the driver expected no temperature difference (tps1) larger than +/-10 between datagrams. Apparently your config does sometimes differ by 34 (692 - 654) resulting in what you see. The temp sensor is either rapid changing or just broken. I'll change the current +/-10 to +/-50 so you should be save then. |
|
i monitored the temperature for some time it's hovering between 67 and 72 degrees (both relay ON) |
|
Yeah, the way the code was written it could start measuring again if the temp fell within the margins. The just released dev branch contains a fix to increase the margin to +/- 40 and keeps the previous temp updated. Precompiled versions are available after an hour from now at http://ota.tasmota.com/tasmota32/tasmota32c3.bin |
this morning power measurement is still working