Repository navigation
Changelog Highlights
djvalic edited this page Oct 27, 2026
·
3 revisions
What changed in the last three releases, in plain words.
The main changes in the last three releases, in plain words. The full list is in the project's CHANGELOG.md.
- The motor current settings for X, Y and Z were changed to values that other AD5X users report working well.
- The first webcam is now named "Chamber/Bed" in Fluidd. The dead camera on the USB port is skipped, so the bed camera is the first camera.
- Homing Y no longer resets the Z height when the head is already on its end stop.
- The toolhead sensor goes back to its earlier state after an IFS colour swap.
- The print start purges less filament when the colour is already in the nozzle.
- Print start stops with a clear error if the bed or nozzle temperature is not a number.
- A print with no saved Z height now runs the bed mesh first.
- If Kiln OS has no record of a loaded slot, Unload now unloads the slot the IFS reports as loaded.
- A failed IFS unload releases the slot, so you can pull the spool out by hand.
- The board fan stays on during long macros, such as bed levelling, and turns off 30 seconds after the print or motors stop.
- Wi-Fi no longer crashes at start-up on some USB adapters.
- Wi-Fi regional settings are built into the system, so the country is set correctly.
- The touch screen says IFS everywhere: in the messages, the setup wizard and the print start text.
Kiln OS is free, open firmware for the AD5X. Not made by or endorsed by Flashforge. · Report a bug · Source code · Releases · Sponsor