esp32-cam board

Repository consists of several parts:

• micropython firmware ( already built .bin file in firmware directory )
• micropython implementation of test program ( morse code with LEDs on camera )
• micropython implementation of camera webserver

Camera setup

• cable connection is described in file plug.txt
• to program the board I used MU editor
• to connect the board to PC via serial port I used FTDI programmer ( little board with USB present )
• as a source of power I used classic phone powerbank ( while programming, board is getting power from your PC )

Flashing

• When using the board for the first time, you will need to "flash" the firmware ( for example the one located in firmware directory ) in order to communicate with the board.
• For this purpose, there are several tools available. I used esptool program ( which is also built-in in MU editor ).
• You will need to plug one extra cable in order to flash the firmware ( as stated in plug.txt file ). After flashing, you can easily remove it.