ble_log_console_v1.1.0

This release adds capture from the USB Output port, decodes the internal BLE Log frames that carry device-side statistics, and makes loss accounting and save-failure reporting accurate.

What's New

• USB Output capture: Record from the DUT's USB CDC-ACM port with --mode usb, in addition to UART and the USB-SPI Bridge.
• Device identification: Internal snapshot and version information frames are decoded, and the status bar shows the chip name and revision reported by the DUT.
• Per-source loss accounting: Frame sequence numbers are tracked as one global stream, and firmware-side loss is attributed per source and per segment, so a recording reports where data was lost instead of only how much.

Improvements

• Recording file synchronization failures no longer pass silently: the quality report marks the recording for a repeat capture and keeps the raw data already written.
• Bilingual configuration guides added; the user guides and the intake skill were refreshed.
• UART and SPI Bridge now share one serial transport implementation, covered by tests that drive a real PTY.

Usage Note

End recordings with Stop & Review, q, or Ctrl+C, and wait for finalization to finish. Closing the terminal directly may leave the final data and report incomplete.

ble_log_console_v1.0.4

This version improves redirected serial console log handling.

ble_log_console_v1.0.3

BLE Log Console Release

This release improves BLE Log Console stability and performance during high-throughput captures.

The capture backend has been redesigned so raw log saving is separated from live parsing and UI rendering. Raw .bin capture is now the reliable path: if data is accepted by the IO stage, it must be written to disk, and any writer failure is reported clearly.

Live parsing and statistics are optimized with batching and metadata-only frame events, reducing memory usage and UI stalls when the parser temporarily falls behind. A native Cython checksum fast path is also included when available to improve parser throughput.

Main Changes

• More reliable raw .bin capture
• Faster calculation with optional Cython acceleration
• Improved packaged executable behavior

This release is recommended for users capturing BLE logs, especially over SPI bridge.

ble_log_console_v1.0.5

This release adds capture quality reports and improves the workflow for stopping, reviewing, and repeating log recordings.

What's New

• Capture quality review: After recording, view a clear result: Ready for Analysis, Saved with Warnings, or Recapture Recommended.
• Stop & Review: Safely stop recording, save remaining data, and open the quality report. Start another recording with the same settings directly from the report screen.
• Saved reports: A matching _report.txt file is saved alongside each capture for troubleshooting and sharing with technical support.
• Language selection: Choose English or Chinese for warnings and quality reports.

Improvements

• Refined segment-based quality reporting, including sequence continuity checks and firmware write-failure statistics.
• Clearer distinction between raw data saved and data covered by the quality check. Incomplete checks are marked as unverified.
• Shorter English and Chinese user guides, updated screenshots, and refreshed PDF documentation. Source setup and command-line references are now available in the README.
  -- Made a warning for cases where no logs are parsed more prominent. If this happens, please check the configuration.

Usage Note

End recordings with Stop & Review, q, or Ctrl+C, and wait for finalization to finish. Closing the terminal directly may leave the final data and report incomplete.

ble_log_bridge_v1.0.0

This release introduces BLE Log Bridge, a standalone utility for forwarding BLE logs from a target device to the host environment.

BLE Log Bridge uses an ESP32-P4 as the bridge device. BLE-related logs are collected from the target device through the SPI interface and then transferred to the host for logging with USB.