Hardware Reports

Hardware reports

Devices this integration has been run against, as reported in the issue tracker. The write column is what matters most: the export controls are a beta because too few people have confirmed them on real hardware, the battery controls need no flag but are just as unconfirmed, and every row here moves that along. Fronius, SolarEdge, SMA and Kostal now have their own vendor profiles, built from vendor documents and community sources rather than project hardware; their own "Reporting back" sections in docs/ are the place for those.

Device	Firmware	Blocks seen	Reads	Writes	Source
KACO Powador 7.8 TL3		1, 103, 160	yes	no control blocks	development device
KACO blueplanet 9.0 TL3		103, 160, 123	yes	123 export limit, driven for two years through a proxy before the beta existed	#17
KACO bp 20.0 NX3 M2	V610-03043-06	123, 704	yes	123 and 704 export limit in percent work. The limit lapses after the revert time. Watt setpoint on 704 not confirmed	#17, #42
KACO NH3				124 not established	#32
Fronius Symo GEN24 4.0	1.41.10-1, 1.41.11-1	103, 123, no 704	yes	123 export limit confirmed: 20 % of a 4000 W WMax measured as 799 W. A changed limit takes effect after the enable flag is written again	#17, #45, #49
Fronius GEN24 SC Plus with BYD 60 kWh		103, 123, 124	yes, reported stable	124 not yet tried	#57
SolarEdge (model not named)		1, 103, ...	yes, on port 1502		#25
Kostal PIKO CI 50			yes		#52
Kostal PLENTICORE, PIKO IQ			no report yet		profile from the interface description, docs/kostal.md
SMA Sunny Tripower X		701 family, 714	yes, 714 vanishes for hours in low light		cjne/ha-sunspec#202, via the standby handling

Adding yours

One issue with:

1. Make and model, and the firmware version (Vr on the device card, or in latest_values under "1" in the diagnostics download)
2. The detected_models array from the diagnostics download
3. If you use the write controls: which entity you wrote, what value, and what the inverter did. A measured power reading beats a read-back value, because block 123 reads back whatever was last written regardless of what the inverter is doing.
4. On a Fronius, SolarEdge, SMA or Kostal, the vendor field at the top of the diagnostics download (fronius, fronius_datamanager, solaredge, sma or kostal) says which profile applied, and raw_blocks shows the vendor registers behind the entities you tested. An empty vendor on a device you expected a profile for is worth reporting on its own.

Two clean write reports per block are what takes the BETA flag off.