SPEEDYBEEF405WINGV2 – Manual mode does not activate when AUX enters valid range (INAV 9.0.1)

[crstacey]

Board

SpeedyBee F405 Wing APP (V2)

Target

SPEEDYBEEF405WINGV2

Firmware

INAV 9.0.1 (full chip erase performed before flashing)

Configurator 9.0.1

---

Issue

Manual mode does not activate when AUX channel enters the configured range.

---

Steps to Reproduce

1. Perform full chip erase and flash INAV 9.0.1

2. Apply minimal AUX configuration via CLI:

   aux 0 0 5 1800 2100
   aux 1 10 4 900 1300
   aux 2 1 4 1300 1700
   save

3. Confirm configuration using diff all

4. Observe receiver values:

   • CH9 low ≈ 989
   • CH9 mid ≈ 1500
   • CH9 high ≈ 2011

---

Observed Behavior

• CH9 high (~2000): No mode selected → Acro works as expected
• CH9 mid (~1500): Angle activates correctly
• CH9 low (~989): Manual does NOT activate (no mode active)

---

Expected Behavior

• CH9 low (~989) should activate Manual mode

---

Notes

• No overlapping AUX ranges
• Fresh flash with no additional configuration
• CLI confirms Manual (mode 10) is correctly stored
• Issue persists regardless of configuration via GUI or CLI
• Appears specific to this board/target combination

---

Additional Info

This was tested after multiple full chip erase flashes and minimal configurations to isolate the issue.