MegaESP Firmware 11.6

Firmware 11.6

• Added configurable Wi-Fi Indicator Output for any OutSW port.
• Added Invert output for the Wi-Fi indicator.
• Added Wi-Fi status blink patterns:
  • Connected: heartbeat (80/120/80/2200 ms)
  • Connecting: fast blink
  • Disconnected: short blink every 2 seconds
  • AP mode: triple blink
• Added Wi-Fi indicator settings to the Config page.
• The selected GPIO port is marked as WiFi LED on the GPIO page.

Flash files in this release

• firmware.bin — main controller firmware
• littlefs.bin — web interface and filesystem image
• sha256.txt — checksums for verification

Typical flashing order

1. Flash firmware.bin
2. Flash littlefs.bin
3. Reboot the controller
4. Open the controller web interface and verify version 11.6

MegaESP Firmware 11.5

Firmware 11.5

• Added two new GPIO ports on the GPIO page:
  • TX (GPIO1)
  • RX (GPIO3)
• TX/RX can now be selected and used with clear UART-related warnings in the UI.
• Added compatibility with previously saved configs after increasing the port count.

Flash files in this release

• firmware.bin — main controller firmware
• littlefs.bin — web interface and filesystem image
• sha256.txt — checksums for verification

Typical flashing order

1. Flash firmware.bin
2. Flash littlefs.bin
3. Reboot the controller
4. Open the controller web interface and verify version 11.5

Related project

• Home Assistant integration: https://github.com/ihhorm/megaesp-ha

MegaESP Firmware 11.4

Firmware 11.4

• Added Permit Input as a regulator condition/block input
• Added Invert output support for all regulator types
• Updated regulator web UI controls
• Includes current MegaESP controller web assets and LittleFS sources

Flash files in this release

• firmware.bin — main controller firmware
• littlefs.bin — web interface and filesystem image
• sha256.txt — checksums for verification

Typical flashing order

1. Flash firmware.bin
2. Flash littlefs.bin
3. Reboot the controller
4. Open the controller web interface and verify the version

Related project

• Home Assistant integration: https://github.com/ihhorm/megaesp-ha