SGW Training

Setup

1. Single Node Setup

Note

This setup will not use any custom docker networks and it will contain a basic 1-1 mapping of CB and SGW

• Create CB container:

docker run -d --name cb_0 -p 8091:8091 couchbase:latest

• Initialize the cluster and create a bucket

• Inspect and get the IP address of the node

docker inspect $(docker ps -aq) | jq -c '.[] | [.Name, .NetworkSettings.Networks[].IPAddress]'

• Ensure that the IP address in config1.json is same as the IP address obtained from the above command

• Start SGW container:

docker run -d --name sgw -p 4984-4986:4984-4986 -v ./config1.json:/etc/sync_gateway/config.json couchbase/sync-gateway:enterprise

• Test if SGW is running by running the following curl command:

curl localhost:4984

2. Multi Node Setup

Note

This setup will use any docker networks

• Create docker network

docker network create -d bridge --subnet 10.0.0.0/8 my-bridge-network

• Start docker containers for Couchbase:

docker compose up cb-server1 cb-server2 cb-server3 -d

• Initialize the cluster and create a bucket (ensure flush is enabled)

• Start SGW container

docker compose up sgw -d