Customizing the ETK Installation

Jump to bottom

mercurious edited this page Jun 19, 2026 · 1 revision

Customizing the ETK

The first run generates etk.conf from etk.conf.example
- RIG_SSH — auto-populated to root@<SOC>.local; replace with a literal IP if your LAN blocks mDNS
- ETK_BUILD_TYPE — FULL (shaders + thermal + HUD) / LITE (thermal + HUD) / RAW (HUD only)
- DEFAULT_MODE, HUD_HEADER_HOLD_S (HUD launch-banner hold)
- ETK_VERBOSE — 0 = Pit Wall console TUI (default), 1 = raw rsync output for debugging. Pass --verbose / -v on the install.sh CLI to force verbose for a single run.
Re-run ./install.sh after any etk.conf edit to push changes to the rig.
Reboot the rig once to activate the ETK Pitstop entry in the ROCKNIX Tools menu.