v0.12.2

Changes

• Fixed the 4.3C gradually losing its network features. On a machine with a
  scale paired and an SD card in, the remote could reach a state where checking
  for updates failed, the log page wouldn't load, and the WiFi/token setup portal
  would advertise but refuse to let a phone join it — all at once, and only
  clearing on a restart. The board had run out of a specific kind of internal
  memory that the radio, the display and encrypted connections all draw from.
  Apollo now uses roughly 26 KB less of it, which restores all three.
• Fixed the "Check for updates" setting rendering in a smaller font than the
  buttons above it in Settings > Device > WiFi.

---

Apollo 2 firmware v0.12.2 — one flashable image per supported
Waveshare board (bootloader + partitions + app combined; flash at
offset 0).

Easiest install: the web flasher —
plug the board in and flash from Chrome, no tools needed.

The flasher upgrades in place: your paired machine, Wi-Fi and
settings survive unless you explicitly choose to erase.

Command-line alternative — note the attached .bin is a full
image, so flashing it this way DOES clear saved settings:

esptool.py write_flash 0 apollo2-<board>-v0.12.2.bin

(apollo2-debug-symbols-v0.12.2.tar.gz is for developers:
the .elf files inside decode crash dumps downloaded from a device's
/coredump page.)