3D Case - Printer Settings #153
|
So I started to print the case tonight while we wait for parts to arrive. The print failed twice. I suspect my filament may be too wet so I'm running it through my dryer. In the meantime, has anyone printed the case on a Bambu P1S and was there any printer settings changes needed? |
Replies: 1 comment
|
Okay, I figured it out. If you print the sensor housing on it's back like the picture suggests, there is a small gap where the logo is inserted that is against the printer bed. Using supports will cause Bambu to try and fill that gap which results in the first solid layer NOT adhering. So my solution was to fill that gap (the block I added is in red) and that solved the printing issue. I'm going to print the logo eventually and just glue it to that same spot so on mine it will stick out a bit but that's okay. Here's the block I added using Tinkercad: 
There might be a setting in Bambu Lab that would solve this but I could not find one. I can add my .stl file if anyone is interested. |
Okay, I figured it out. If you print the sensor housing on it's back like the picture suggests, there is a small gap where the logo is inserted that is against the printer bed. Using supports will cause Bambu to try and fill that gap which results in the first solid layer NOT adhering. So my solution was to fill that gap (the block I added is in red) and that solved the printing issue. I'm going to print the logo eventually and just glue it to that same spot so on mine it will stick out a bit but that's okay.
Here's the block I added using Tinkercad:
There might be a setting in Bambu Lab that would solve this but I could not find one. I can add my .stl file if anyone is interested.