v0.1.13 firmware improved glasses compatability and irled off when not used

• Improved performance on PWM displays
  • Install v18a firmware to gain access to new settings for PWM displays.
  • Optimal settings for PWM displays are as follows
    • OPT Block Signal Detection Delay (set to just longer than the PWM backlight pulse length normally 1000 works well for 720hz displays)
    • OPT Ignore All Duplicates (set to 1 to block all subsequent PWM pulses after the first one)
    • The below mode and settings are optional but gives a much stabler result if your PWM backlight is not phase locked to the monitor refresh rate (most monitors aren't as far as I can tell)
      • IR Average Timing Mode (set to 1 to enable, this will compute the actual average frame time and use it to start a timer which will be resynchronized with updated average frametime every second)
      • Target Frametime (set to 8333 micro seconds for 120 hz)
      • PWM Backlight Frequency (set to your PWM backlight frequency which you can find on https://www.rtings.com/tv/tools/table/138933 when in doubt use a value slighty higher but lower than double your PWM backlight frequency. For example for a 720hz backlight frequency values between 680 and 1300 miroseconds should work)
• Sensor debug log mode now outputs IR setting parameters at the end of the file.
• Other bug fixes
• I have 50 PCB's partially assembled so I'm ready for more beta testers either open a github issue or email at support at open3doled dot com

Full Changelog: v0.1.11...v0.1.13