Skip to content

Releases: osait98/centauri-monitor

Release list

v1.0.0.

v1.0.0. Latest
Latest

Choose a tag to compare

View all tags
@osait98 osait98 released this 04 Aug 20:35
v1.0.0
1d23102

Elegoo CC1 Monitor v1.0.0

Initial release. OLED status display + web configuration panel for Elegoo Centauri Carbon printer running on an ESP32-C3.

Flash the firmware

  1. Download merged-centauri-monitor.bin from this release's assets.
  2. Put the board in flash mode: hold BOOT button, plug USB in, wait few seconds, release BOOT.
  3. Open https://web.esphome.io/ in Chrome or Edge.
  4. Choose Connect.
  5. Select your serial port.
  6. Choose Install(not Prepare for first use!) and choose .bin.
  7. When it finishes reset device. Wait few secends before power up.

First-time setup

  1. The board boots into setup mode: connect to WiFi network ElegooMonitor, password elegoo123.
  2. Open http://192.168.4.1, pick your home WiFi network, enter the password, and save. The board restarts and joins your network.
  3. On the Settings tab, enter your printer's IP address and save.
  4. The panel is now available at http://elegoo-monitor.local or the board's IP (visible in your router).
Assets 3
Loading