Skip to content

Using MPLAB IPE to write prlpSecureBoot and prplHypervisor to flash

Jump to bottom
Marcelo Veiga Neves edited this page Mar 24, 2017 · 7 revisions

Connect to board

Select the appropriate Device (e.g., PIC32MZ2048EFM144) and click on "Connect" button.

Step 1

Write prplSecureBoot

Load prplSecureBoot image (Microchip_Eth_Starter_Kit_SecureBoot.hex) and click on "Program" button.

Step 2

Write prplHypervisor

Go to Settings > Advanced Mode > Memory.

Step 3

Uncheck the "Allow Tool to select memories and ranges" option. In the Manual select area, check "Programa Memory" and "Configuration Memory. Change the "Program Memory Range" to 0x1D000000 - 0x1D01FFFF.

Step 4

Uncheck the "Erase All before Program" option.

Step 5

Load prplHypervisor image (firmware.hex) and click on "Program" button.

Step 6

Clone this wiki locally