[ESP600] command in Start or End G-Code (ESP3D)

[DROID8622]

Version

2.0.0+win64

Operating system type + version

Windows 10 x64

3D printer brand / version + firmware version (if known)

Custom

Behavior

I am trying to use [ESP600] command in the End G-code to send notification , but it says failed due to invalid custom G-code sections

[lukasmatena]

If you want to add [ESP600] into the gcode and prevent the parser from evaluating the inside of the square brackets, you have to mark it as string, that is
{"[ESP600]"}

[lukasmatena]

I added a mention of this construct in the respective wiki page.

I assume this solves the issue. Closing.