Skip to content
This repository was archived by the owner on Sep 26, 2024. It is now read-only.

Releases: redhat-et/jumpstarter

Archived version for Jumpstarter single-binary

Choose a tag to compare

@mangelajo mangelajo released this 12 Aug 15:27
0.4.1

Update readme

Longer wait before we sync and switch off the USB disk

Choose a tag to compare

@mangelajo mangelajo released this 14 Dec 17:02
0.3.3

Update storage.go disconnect time

Make udisksctl call non-fatal

Choose a tag to compare

@mangelajo mangelajo released this 24 Oct 12:07

When using jumpstarter from containers udisksctl doesn,t fully work, we
need to switch to using sys bus "eject" as described in #3 instead.

For now we just warn about the issue.

Support for storage_filter

Choose a tag to compare

@mangelajo mangelajo released this 13 Oct 08:51

Now, it's possible to filter the storage that Jumpstarter will try to use for image writing; this is useful when storage devices present multiple block interfaces, or when there are multiple jumpstarters working on the same host.

The detection of devices works by looking at /dev/disk/by-id/ and the storage_filter must be one part of the path.

Add power-on/off profiles

Choose a tag to compare

@mangelajo mangelajo released this 10 Oct 16:04

This version adds a few new commands:

  • power which allows a power profile (on, off, force-on, force-off, rescue) which
    will use the 0.06 feature of the firmware to run a small scriptlet to handle power via pins:

i.e.:
jumpstarter power rescue orin-nx-00
jumpstarter power off orin-nx-00

  • set-config, which allows setting config parameters stored into the board.

  • get-config, which allows gett config parameters from the board:

# jumpstarter get-config orin-nx-00
name: orin-nx-00
tags: orin-nx-00,orin,orin-nx,16gb
json:
usb_console:
power_on: p1,bL,w5,bZ
power_off: p1,bL,w5,bZ,w10,bL,w110,bZ
power_rescue: p1,bL,w1,bZ,w1,aL,rL,w1,rZ,w1,aZ

New scripting format

Choose a tag to compare

@mangelajo mangelajo released this 06 Oct 11:34

The scripting format has been updated to not be similar to ansible,
avoiding confusion created around this.

A workaround for NVIDIA AGX Devkit console has been added.

New jumpstarter-playbook tasks

Choose a tag to compare

@mangelajo mangelajo released this 19 Sep 13:37
  • write-ansible-inventory
  • local-shell

Add create-ansible-inventory and run commands

Choose a tag to compare

@mangelajo mangelajo released this 15 Sep 16:57
0.1.4

Add create-ansible-inventory and run commands

avoid mixing fmt.Println and Stdout

Choose a tag to compare

@mangelajo mangelajo released this 14 Sep 14:46

Hopefully this will fix some missing output in gitlab-runner.

retry out-of-band console opening

Choose a tag to compare

@mangelajo mangelajo released this 12 Sep 13:28

Sometimes the AGX console shows up but takes a few
seconds to actually be available.

This will retry opening OOB consoles.