writing to entiteit goes wrong #37
|
I’m very grateful with this integration, thanks for all the work! I’m playing with it an working on a automation where I can conditionally change the heatcurve_1_setpoints (1-5), it’s for optimizing the room temperature. What I experience if I want to send a value of 24 to the setpoints, it returns to 25 (instead of 24 what I was expecting). If I do that for the heatcurve_2_setpoints, it works fine. It looks like a kind of setpoint of minimal 25 for the heatcurve_1_setpoints. Is this correct? Or did I set it myself, while I’m not aware of it? (If I change it on the Amber itself via the menu, it works fine, when I want to change it again via HA then it returns 25 again.) Someone knows what this could be? |
Replies: 1 comment 1 reply
|
Hi, |
|
Thanks, good to know. |
Hi,
There are some mismatches in the value's you can set via modbus and the display. This one I was not aware of.
The ones I do know are mentioned in the Readme.
Just discovered that the minum tempetrure setting in the modus voor heating without heatcurve is 24 for zone 1 and 25 for zone 2