Enable NMEA sentence GNZDA

[Corsair-63]

Good day all,

I've done with the U-center 25.06 in windows 11 ARM64 to enable from GNSS receiver u-blox gen10 the NMEA sentence GNZDA.

but the problem is that on board I've Raspi 5 with trixie on SSD and newly installed PyGPSClient, it is working well, but I want to enable this sentence too in a same u-blox gen 10 receiver but I'm unable to find the process. and keep the receiver with the same sentences that is sending now plus GNZDA. by default, I guess that this sentence is locked, but via u-center you can enable.

any hint / help will be Welcome.

[semuadmin]

Hi @Corsair-63

1. Connect to your receiver - I'm assuming you're using the USB port.
2. Open the UBX Configuration Panel by clicking this button:

3. Navigate to the CFG-VALSET/DEL/GET Configuration Interface panel.
4. Select the Category CFG_MSGOUT_NMEA.
5. Select the Keyname CFG_MSGOUT_NMEA_ID_ZDA_USB (or _UART1 if you're using the UART port instead).
6. Check the CFG-VALSET box.
7. Enter a Value of 1 in the Value field.
8. Click the Send button (green arrow).
9. If the configuration command is successful, a green tick should appear next to the Send button:

10. I recommend having another look at the PyGPSClient README, and reviewing your particular receiver's Interface Specification.

[Corsair-63]

Hi semuadmin,

thanks for the reply, I'm using the uart0 connection of Raspi 5 (GPIO) pins 6,8,10

[Corsair-63]

thanks a lot, done using ZDA_UART1

[semuadmin]

There you go 👍