Skip to content

Exploring the TS Pico

David Anderson edited this page Dec 20, 2023 · 1 revision

The TS Pico has a few hardware features worth exploring before jumping into using it. First and foremost is the Raspberry Pi Pico, an embedded computer designed to support all kinds of projects. The TS Pico uses a custom MicroPython program, in conjunction with a modified version of the TS 2068 operating system, stored in the Flash ROM, to add features to your TS 2068.

Raspberry Pi Pico

The Raspberry Pi Pico has an LED on it that indicates its status. The LED will blink about once a second when the Pico is idle and waiting for a command.

The LED will turn on and stay on when Pico is processing a command or waiting for input from you.

On the off chance the Pico gets confused or a command doesn’t perform as expected, the Pico and your computer will appear to pause, for several seconds. Eventually, the watchdog timer in the Pico will cancel the command and reset its buffers. You’ll likely see the LED go dark when this happens.

Pushbuttons

There are three pushbuttons on the TS Pico: Pico Reset, TS Reset and NMI.

At the time this manual was written, only the TS Reset button works. Pressing it will reset your TS 2068.

Jumpers

The TS Pico has several jumpers worth noting.

  • JP1 configures how the TS Pico works with other devices when plugged into the expansion bus. When used with the appropriate jumper on the expansion bus, the TS Pico can recognize when a device “behind” it wants to take control of the computer via the /BE signal and will get out of that way of that device.
  • JP2, JP3 and JP5 are optional. They allow you to connect a remote switch for the switches. They’re useful if you want to put your TS Pico and expansion bus in a 3D-printed enclosure, for instance.
  • JP4 selects the IO port range the TS Pico will recognize. It defaults to port 14 and the 0..F range should be jumpered.
  • P10 controls the Write Enable line on the Flash ROM. When there’s no jumper on these pins, it’s impossible to reprogram the Flash ROM.

The Two Big Chips

Right next to the Raspberry Pi Pico are two large chips. The chip in the middle is 512K of static RAM; it is soldered directly to the circuit board.

The chip further right is the Flash ROM. It’s in a socket. If upgrades to the Flash ROM become available, you’ll be able to remove this chip from the TS Pico and reprogram it yourself or replace it with another programmed Flash ROM chip.

The SD Card Slot

At the upper right corner of the TS Pico is the SD card slot. This is where your TAP files are stored.

You should always have a card in this slot, especially when you turn the computer on. The TS Pico will attempt to mount and get a directory of files on the SD card when the computer is powered on.

Clone this wiki locally