Skip to content

Installing the TS Pico

David Anderson edited this page Dec 20, 2023 · 1 revision

Turn off your TS 2068 before connecting the TS Pico to your computer.

Remove any cartridges from the computer.

The TS Pico comes in two styles: direct connect and expansion bus.

The direct connect style plugs into your computer and will extend horizontally. When you plug it into your computer, line up the key with the key slot on the expansion connector and press the board in until it is firmly attached.

The other style plugs into an expansion bus that is in turn plugged in to your TS 2068. With this style, line up the slot on the TS Pico board with the key in the slot on the expansion bus and press firmly until it is seated in the connector.

Next, plug the expansion bus (which is also keyed) into the TS 2068.

Regardless of which style you have, you’ll notice a fair amount of resistance plugging the card into the slot or on to the expansion bus on the back of the computer. This is normal.

In both cases, the TS Pico has a “key” in the appropriate slot to ensure it plugs in correctly.

Turn on your computer and, if the interface is recognized, you will see the normal Sinclair and Timex copyright notices along with a new notice from the TS Pico after a few seconds.

Clone this wiki locally