Repository navigation
ZX Spectrum Mode
The TS-Pico includes a TS2048 ROM in the Flash ROM. This ROM allows you to use the Pico in "Spectrum mode."
There's not a lot of free space in the TC2048 ROM, so it has not been customized with TPI commands like the TS 2068 ROM.
Make sure your DCK/ROM configuration is the default: DCK Slot 0, ROM Slot 1. If you have not modified config.ini, or issued SAVE "tpi:memboot" or "tpi.memdock" commands, you'll be fine.
Change to the directory where the ZX Spectrum TAP file is that you want to use and mount it with LOAD "tpi:filename.tap"
You can use TPI commands like tpi:tapdir at this point.
Do not LOAD the file within the TAP
Note: You don't have to mount a TAP file prior to switching if you just want to use the ZX Spectrum mode and SAVE your work.
Before switching to ZX Spectrum mode, you need to tell the TS-Pico to stop interpreting TPI commands. To do so, use SAVE "tpi:zx48". This switches the TS-Pico to a special "ZX Spectrum" mode that does not not interpret TPI commands.
On the 2068, use OUT 244, 3 to activate the Spectrum ROM cartridge. The 2068 should "reset" and display the single Sinclair copyright message.
The 2068 may hang: if that happens just hit the TS RESET button on the TS-Pico.
You're now in ZX Spectrum mode (actually, TC2048 to be accurate)!
All Save/Load/Verify/Merge commands are directed to the TS-Pico.
If you mounted a TAP file, you can load with the usual LOAD "". If it's a BASIC program, you can modify it and SAVE for later use.
Once you're done with the ZX Spectrum mode, you might want to return to the full-fledged TS2068 mode.
Before you do that, you need to tell the TS-Pico to start listening to TPI commands again. Do that by issuing an OUT 10,100 command.
Next, switch to the TS 2068 ROM with OUT 244, 0.
Your TS might do some weird stuff: a simple TS Reset will restore full functionality.
A couple observations:
-
Weird stuff can happen by mounting some TAPs, as there's only basic support for SLVM ZX Spectrum.
-
As you can't use any TPI commands in Spectrum mode, you can only LOAD the TAP you've mounted while in TS mode, and can SAVE to a file but you can't LOAD the file you've just SAVEd. To do so, you need to restart the system, mount the recently SAVEd ZX Spectrum file, and repeat the mode switch procedure.