How to switch from Birdnet-Pi?

[WP-Romain]

Hey there,

I'm using Birdnet-Pi since a while now. I'm a newbie and I used the installation guide. Very complete!

For Birdnet-Go, it's not so obvious to install and use, actually. The guide is not so complete.

Per example, once installed, with Birdnet-Pi, I can access to the UI via my browser here: birdnetpi.local

How do I access to Birdnet-Go UI exactly? Can I access it via my browser or do I have to install an App on my computer?

Thanks for your precious help!

Bests,
Romain

[tphakala]

On main page of this repository is two command install process:

curl -fsSL https://github.com/tphakala/birdnet-go/raw/main/install.sh -o install.sh
bash ./install.sh

Did you try this?
Is should be very simple, once installed you will see address where BirdNET-Go is accessible over network.

[WP-Romain]

Thanks for your reply!

Yes, I retried this.

But, once I get the message:
Please log out and log back in for group changes to take effect, and rerun install.sh to continue with install

I log out and back then relaunch:

curl -fsSL https://github.com/tphakala/birdnet-go/raw/main/install.sh -o install.sh
bash ./install.sh

But it fails:

And I cannot see any address where BirdNET-Go is accessible over my network.

[tphakala]

Okay thanks for feedback, I have not tested installer on Debian 11 (Bullseye), only on Debian 12 (Bookworm).

Can you try to install jq apache and netcat-openbsd using commands

sudo apt update
sudo apt install jq apache2-utils netcat-openbsd

If installation succeeds run installer again

bash ./install.sh

[WP-Romain]

Thanks Tim!

It works 😊

I will reinstall from scratch on Debian 12 (Bookwork).