Repository navigation
Bluetooth
Bluetooth on the Kindles that have it: turning it on and off, pairing headphones and speakers, connecting to them.
Which Kindles: those with Bluetooth, on firmware 5.x — the Kindle 8th generation and later, Oasis, Paperwhite 4 and newer, Scribe, Colorsoft. On the Kindle 2, 3, DX, 4, Touch, the Paperwhites 2 and 3 and the Nooks there is no Bluetooth row (they have no Bluetooth, or no way to manage it).
The row comes right after Wi‑Fi.
- The tick turns Bluetooth on or off. Turning it off disconnects what was connected first.
- A tap on the row opens Bluetooth devices. If Bluetooth is off it is turned on, then the Kindle searches for devices for about ten seconds ("Searching for devices…"). The list shows paired devices and the ones found nearby, with Connected, Paired or Available beside each.
-
A tap on a device offers what can be done with it:
- Pair — a device found nearby. Put it in pairing mode first (usually: hold its power or Bluetooth button until a light flashes).
- Connect / Disconnect — a paired device.
- Forget — unpair it (it asks first).
- Info — its name, address, signal and status.
GZreader uses Amazon's own Bluetooth service (com.lab126.btfd), so devices
paired here are paired in Amazon's Settings too, and the other way round.
Like Amazon's own Settings, it pairs audio devices (headphones, speakers,
car adapters); a device that asks you to type or confirm a code may not
pair.
In Controls, right after Wi‑Fi (Kindles with Bluetooth only): a tap turns Bluetooth on or off and the panel stays open; the tile shows Bluetooth (drawn black) when it's on, Bluetooth off when it's off, Bluetooth… while it switches. A hold opens Bluetooth devices, as the Settings row does. Settings → Interface → Quick panel can take it off the panel.
Audiobooks, music and read aloud, through Bluetooth headphones or a speaker (these Kindles have no speaker or headphone jack): connect one here first. See Audiobooks and Read Aloud and Music.
The log (crash.log) has Bluetooth lines for power changes and device counts; device names and addresses aren't written to it.
Installing
- Installing
- Jailbreaking and rooting
-
Kindle 2, 3, DX ·
kindle-legacy -
Kindle 4, Touch ·
kindle -
Touch Kindles, firmware ≤ 5.16.2 ·
kindlepw2 -
Touch Kindles, firmware 5.16.3+ ·
kindlehf -
Nook 1st Edition ·
nook-1st-edition -
Nook Simple Touch ·
nook - Updating and uninstalling
Using it
- Using GZreader
- Setup page and connections
- Grimmory library
- Grimmory sync
- Home and bookshelves
- Picture books
- Notes
- Calendar
- Music
- House (Home Assistant)
- Audiobooks and read aloud
- Sync with a computer
- Wi‑Fi: on, off, auto
- Bluetooth
- Updates and test builds
- Privacy and diagnostics
- Nook 1st Edition
- Nook Simple Touch
Under the hood