Repository navigation
Power options
- Short 12V solder jumper
- Short JP1 so that board is powered from LDO
- Voltage on 12V video connector pin should not exceed 16V (3S battery)
- Board will get hot when using this method (LDO will heat) but that should not be a problem
- You can add a small heatsink over the LDO (U10) to help dissipating the heat
- Open 12V solder jumper
- Short JP1 so that board is powered from telemetry connector pin
- Don't exceed 5.5V on the 5V telemetry pin
