-
Notifications
You must be signed in to change notification settings - Fork 1
Launcher Tile
NoStepOnDeez edited this page May 16, 2024
·
1 revision
A spring-powered launcher tile.
Trigger: Pull back spring-loaded tab and release to launch the ball. Watch your eyes!
- McMaster 9044K11 extension spring
- Plastic-safe grease
- Recommended to NOT print in PLA or composites, but rather a low-friction filament not specified.
- Supports required.
- Rules Card Required.
After printing and cleaning up, use a Q-tip or toothpick to apply a plastic-safe grease to the slider track, and use tweezers to install a McMaster 9044K11 extension spring on the pegs below. Depending on your printer's support interface settings, you may need to thin the pegs down with a craft knife to fit the spring.