Repository navigation
Beta testing guide
Note
HACS will always replace the entire integration folder during updates, so there will be no code leftovers from the previous version. All existing devices, entities, recorded data etc will remain, unless explicitly addressed by the code of the new version installed.
If you want to try out the latest beta, please proceed as follows:
- Go to HACS,
- search for SAMSON TROVIS 557x and open the integration,
- click the three-dot menu on the right, choose
Update information, - click the three-dot menu again and choose
Redownload, - a window will appear that lets you choose from all releases on GitHub,
- pick the topmost item marked
Pre-release, - choose
Downloadand restart Home Assistant when asked to do so. Done.
You can revert back to the latest official release version the same way. Just pick the topmost NON pre-release item on the list.
Important
After installing the beta, in some cases HA will probably show you an update notice again. Do not install that offered 'update', as it will automatically revert back to the latest release version.
Disclaimer: Any information on this wiki is informal advice only. It is not supported nor endorsed by Samson, Sauter, YADOS, Pewo or any other equipment maker or OEM. There is no warranty expressed or implied: you take sole responsibility for everything you do with your heating controller.
-
Wozu dieses Projekt?
What is this project about?
-
Wie funktioniert das?
How does it work?
- Was wird benötigt? Kosten?
What's required? Costs?
- Supported controllers
- Connecting your TROVIS
- Installation and setup
- Current limits and migration
- Troubleshooting
- Architecture and internals
- Connections and transports
- Config flow and reconfiguration
- Coordinator and runtime updates
- Devices and entities
- Writing and write access
- Development and testing
- LAN/WLAN
USR-TCP232-T2, USR-TCP232-410S, USR-K7, USR-DR301 (Hutschiene), Elfin-EE10 (WLAN) - USB
AZDelivery FT232RL, Waveshare USB 2 RS232/485/TTL - ESP
ESP-01, Wemos D1 - SPS
S7 1200, Wago 750-889 - KNX
Masifi Modbus Gateway
- Edomi
- espHome/HomeAssitant
- FHEM
- HomeAssistant
- ioBroker
- KNX
- Loxone
- NodeRed
- openHAB
- SIMATIC Step7
- smarthomeNG
- Tasmota/MQTT
- Wago CODESYS
Wiki - Start