Skip to content

Autoplay and MIDI Mode

André Müller edited this page Nov 13, 2026 · 1 revision

Autoplay and MIDI Mode

The toggle in the top bar, left of BPM, chooses what starts and stops the loops. It shows the current mode; click it to switch.

The mode toggle in the top bar switched to MIDI

Mode The loops play…
Autoplay (default) …whenever the host transport runs. Loop 1 follows the host's song position. With the transport stopped the plugin is silent.
MIDI …while a MIDI note is held. Start and stop are quantised to the host's bar lines.

Autoplay is for arranging: the plugin plays along with your song. MIDI mode is for performing: you decide with a key or pad when the loop pair comes in and when it drops out, and it always lands on the bar.

MIDI mode in detail

  • Any note on any channel opens the gate. Pitch, velocity, length and channel are ignored; a chord counts as one gate. The only exception are notes learned for the pass slots: they no longer open the gate (see Pass Slots).
  • Host running: the first held note starts both loops at the next host bar line, from their beginning. Releasing the last held note stops them at the next bar line, with a short fade-out (about 5 ms). Effect tails ring out.
  • Host stopped: the loops start at once, at the host's last known tempo (120 BPM if it has sent none), and releasing the note stops them at once.
  • Every start is a fresh start: Loop 1 begins at its start and the first Loop-1 region draws anew.
  • A note released before its start bar means nothing plays. A note pressed again while a stop is pending cancels the stop.
  • If the host loops a range that contains no bar line, a pending start or stop happens at the loop wrap.
  • Once started, playback runs from its own start point; it is not re-aligned when the host transport stops, starts or jumps while you hold the note.
  • While the gate is closed the plugin is silent, and the playheads rest at the loop start.
  • All-notes-off and all-sound-off messages release every held note, so a lost note-off cannot leave the plugin playing forever.

Right-click audition works in both modes, whether the gate is open or not.

Switching modes

Switching while the transport runs takes effect at the next bar line; with the transport stopped it is immediate. Switching to MIDI with no note held silences the plugin; switching back to Autoplay follows the transport again.

Where the mode is stored

The mode is saved per plugin instance with your project. It is not part of presets or banks, so loading a preset never changes it.

Pass slots in both modes

Pass slots, SAVE, PLAY and their learned notes work in Autoplay and in MIDI mode. In MIDI mode the gate still decides whether anything sounds; a replay only decides what plays while the gate is open. See Pass Slots.

Clone this wiki locally