Skip to content
This repository was archived by the owner on May 26, 2020. It is now read-only.

Recording codes

Jump to bottom
Wojtek Siudzinski edited this page Mar 27, 2014 · 2 revisions

After connecting receiver (or remote) to Arduino's pin 2 (on Yun pin 3), load ReceiveDemo_Advanced sketch provided by rc-switch library to your Arduino and open Serial Monitor.

Press every button (one after another) and watch serial output. It should look like this:

Decimal: 4527411 (24Bit) Binary: 010001010001010100110011 Tri-State: F0FF0FFF0101 PulseLength: 232 microseconds Protocol: 1
Raw data: 7220,236,696,700,232,232,700,232,700,232,700,700,232,232,700,696,232,232,700,228,700,232,696,696,236,232,696,696,236,232,696,696,236,228,700,232,696,232,700,232,696,232,700,232,696,232,700,232,696,

Note Tri-State and PulseLength values for each button.

Clone this wiki locally