Skip to content

Getting started

bigt92 edited this page Nov 14, 2026 · 4 revisions

English · Italiano

Getting started

This page uses the CAN tab of the ribbon; LIN and J1939 work the same way in their own tabs. You can try everything without hardware using the Simulation driver.

1. Choose the interface

CAN → Hardware Configuration → Driver Selection, then choose your interface (or Simulation). In Channel Configuration set the baud rate of each channel: pick it from the list (10 kbit/s to 1 Mbit/s) or type another value. BUSMASTER-NG remembers the last baud rate you used with each interface, also when you do not save the configuration, and offers it the next time.

2. Load the database (optional, but recommended)

With a database BUSMASTER-NG shows message names and signal values instead of raw bytes.

  • DBC file (Vector CANdb++): CAN → Database → Load DBC (or Ctrl+Shift+M)
  • BUSMASTER database (.dbf): CAN → Database → Database → Associate (or Ctrl+M)

Details in Databases and DBC.

3. Connect

CAN → Hardware Configuration → Connect. The button turns to Disconnect while the bus is active.

4. Watch the traffic

The Message Window (CAN → Measurement Windows → Message Window) lists the messages on the bus.

  • Interpret shows the signals of each message (needs a database).
  • Overwrite keeps one row per message id instead of a growing list.
  • Time Mode switches between system, absolute and relative time.
  • Frequency (Hz) (CAN) shows how often each message arrives, from the time between the last messages ("-" for the first one). In Overwrite mode a message that does not arrive for three times its period (at least 100 ms) turns grey and shows "-" until it comes again.
  • Click a column header to sort the list (CAN: ID, Message, Channel, Time, Tx/Rx, Msg Type, DLC, Frequency); click again to reverse. In Overwrite mode the sorting stays while the bus is connected.
  • View → Hex\Dec switches between hexadecimal and decimal.

Other windows in the same group: Signal Watch (chosen signals with their values), Signal Graph (plots) and Network Statistics (bus load, errors).

5. Send messages

Open CAN → Simulation Windows → Transmit Window.

  1. In the message list, use the empty last row to add a message: type its id, or choose its name if a database is loaded.
  2. Below, set the data bytes or, better, the physical values of the signals (negative values are allowed when the signal can be negative).
  3. Send Message sends it once; with a repetition time and the check box ticked it is sent cyclically while connected. The repetition can be typed as time (Repetition (ms)) or as frequency (Frequency (Hz)): the other one is calculated. The shortest repetition time is 1 ms (1000 Hz) on Windows 10 (1803 or later) and Windows 11 and 2 ms (500 Hz) on Windows 7, which has no timer fine enough: a shorter value is raised to the minimum.

The window can be enlarged: the lists grow with it.

6. Save the configuration

File → Save stores everything (driver, databases, windows, transmit list) in a .cfx configuration file. File → Load opens it again. Configurations of BUSMASTER 3.2.x open in BUSMASTER-NG too.

7. Log to a file

CAN → Measurement Windows → Logging → Configure to choose the log file and its format, then Activate. Log files can be converted (ASC, BLF, Excel, ...) with Tools → Format Converter.

More

The built-in help (Help → View Help or F1) describes every window. Its pictures still show the original BUSMASTER, the functions are the same.

Clone this wiki locally