Skip to content

Troubleshooting

bigt92 edited this page Nov 14, 2026 · 5 revisions

English · Italiano

Troubleshooting

"MSVCR120.dll" or "MSVCP120.dll" is missing

From 3.4.2 BUSMASTER-NG checks this itself at start-up: the message names the Visual C++ 2013 Redistributable and offers to open its download page. Older versions show only the Windows error about the missing DLL.

Install the Microsoft Visual C++ 2013 Redistributable (x86), also on 64-bit Windows, then start BUSMASTER-NG again.

A message says a driver could not be loaded

BUSMASTER-NG tells you which driver file and why, for example:

  • the file ... is missing in the folder ...: the BUSMASTER-NG folder is incomplete. Extract the zip again;
  • Windows cannot load it (error ...): usually the driver of the interface vendor is not installed, or it is a different version;
  • the file loads, but the driver could not be started: the vendor driver is missing, or the interface is not connected.

Then BUSMASTER-NG switches to the Simulation driver, so you can keep working. Install the vendor driver and choose the interface again in CAN → Driver Selection.

If even the Simulation driver cannot be started, the installation is damaged: extract the zip again.

A PEAK channel does not connect

With the PEAK PCAN-Basic driver the reason is written in the trace window:

  • PCANBasic.dll was not found: install the PEAK-System device driver (www.peak-system.com), which brings that file;
  • the channel is used by another program: close it, or set the channel to listen-only under Advanced if you only want to watch the bus. A channel that PCAN-View has open can be connected as well.

The old PEAK USB (Legacy) driver needs CanApi2.dll, which is in the BUSMASTER-NG folder.

"The simulation engine BusEmulation.exe could not be started"

The Simulation driver uses BusEmulation.exe, in the BUSMASTER-NG folder. BUSMASTER-NG registers it for your Windows user by itself; if that fails, open a command prompt in the BUSMASTER-NG folder and run BusEmulation.exe /RegServerPerUser, then start BUSMASTER-NG again. If the folder is on a network drive or blocked by a security program, copy it to a local folder first.

Versions 3.3.0 and 3.4.0 do not show this message: they hang on the splash screen. Update to 3.4.1 or later.

A node does not build

The output window says what is missing before the compiler runs (MinGW, or files of the BUSMASTER-NG folder). See Node simulation.

Messages are shown without names or signals

No database is associated, or the message ids are not in it. Load the DBC (CAN → Load DBC) or associate the .dbf, and switch on Message Window → Interpret.

Signal values look wrong

  • Was the .dbf converted with BUSMASTER 3.2.2? Load the DBC again with Load DBC (see Databases and DBC).
  • Float signals and multiplexed signals have known limits, also explained there.

Windows or text look too small, too large or blurry

BUSMASTER-NG adapts to the display scale of Windows (125%, 150%, 200%). If you change the scale while it is running, restart it. Please report windows that still look wrong, with the scale you use and a screenshot.

The program hangs or crashes

Please open an issue with:

  • the version (Help → About) and your Windows version and display scale;
  • the interface and driver you use;
  • what you did, step by step;
  • for a crash: the Application Error event in the Windows Event Viewer and, if there is one, the dump file in the DumpFiles folder next to BUSMASTER.exe.

Do not attach files with confidential data (customer databases, logs, configurations).

Clone this wiki locally