Fillaprint v0.1.3 beta

Fillaprint v0.1.3 is a beta update of the typeface for small FDM-printed labels. We are fine-tuning the letterforms, spacing, and print behavior for release, with an eventual Nerd Fonts launch as a future target. This is not an official Nerd Fonts release.

Download Fillaprint-0.1.3-beta.zip for all three families, installation notes, and the SIL Open Font License 1.1. Internal OpenType version: 0.103.

What changed since v0.1.2:

• Capital V is wider: 10w of ink (was 9w), as wide as M and W, with the same round point. The wider angle leaves a little less fill in the point.
• Capital Z has longer top and bottom bars: each now runs 0.5w past the opposite mitred corner (Z is 1w wider). The diagonal and corners are unchanged.
• Both were chosen by a reviewer from four options each, shown on the Fillaprint page.
• Fillaprint Mono uses the same V and Z (both fit the 12w cell).
• Spacing and kerning around V and Z changed, so text containing them can reflow.

Try the font, calculate a print size, and view specimens.

Nominal strokes and minimum clear gaps use two extrusion widths. Check your own sliced preview. The fonts were rebuilt from the tagged sources with the pinned dependencies; this release does not claim new physical-print validation.

Replace installed beta fonts and restart your design application when updating. Keep the v0.1.2 ZIP with projects that need its exact layout.

Licensed under SIL OFL 1.1 for personal and commercial use. License and copyright notices are included in the ZIP and embedded in each font.