Calibrate

Calibrating teaches the shifter where neutral, the handbrake and each gear are. Do it after every install, or when a gear is detected wrong. It works with OpenShift and with the stock firmware.

Steps

1. Connect the shifter in the web tool and open the Calibration tab.

2. Put the H/SEQ switch in H and press Start calibration.

3. For each step, move the lever as the page says, hold it still and press the Record button:

   Step	Lever
   Neutral	in neutral, hands off
   Handbrake	pulled fully back
   Gears 1 to 6	in the gear
   Gear 7 and Reverse	pushed down to unlock, then in the gear

4. Unplug the shifter and plug it back in. The calibration is already saved, but the shifter keeps adjusting the gears until it restarts.

Skip keeps a step as it was. Back goes to the previous step so you can record it again.

Sequential thresholds (optional)

These set how far the lever has to move before a shift counts. Tick Also set the sequential thresholds before you press Start. Two steps are added after Handbrake:

Step	Switch	Lever
Shift down	SEQ	pushed forward
Shift up	SEQ	pulled back

Put the switch back in H for the gear steps. The page tells you when.