Repository navigation
Troubleshooting
github-actions[bot] edited this page Oct 20, 2026
·
1 revision
| Problem | What to do |
|---|---|
| The page says the browser cannot reach USB devices | Open the page in Chrome, Edge or Opera on a computer. For Firefox, see Firefox. |
| The shifter is missing from the browser's list (Linux) | Install the udev rule from Install, then unplug the shifter and plug it back in. |
| "Could not connect" or "could not open the shifter" | Close VelocityOne Tuner and any other program that uses the shifter, then try again. On Linux, check the udev rule. |
| The update stopped halfway | The shifter waits in update mode. Connect it again in the web tool, open the Firmware tab and install again. |
| The shifter does nothing after an update | Start it in update mode by hand (below), then install again. |
| A gear is detected wrong | Calibrate again, then unplug the shifter and plug it back in. |
| No gear shows right after plugging in | Move the lever through neutral once. |
| The Settings tab says it needs OpenShift | The shifter runs the stock firmware. Install OpenShift first. |
| Linux: games see two shifters, or every press twice | You have the hid-velocityone-multi-shift driver installed. OpenShift does not need it: stop and remove it. |
Use this if OpenShift is installed but the shifter does not work.
- Unplug the shifter.
- Hold down both buttons on the shifter, High/low and Handbrake.
- Plug it back in while you hold them, then let go.
- Connect it in the web tool. Only the Firmware tab is shown. Install any firmware.
OpenShift also starts update mode by itself if it crashes or hangs.
Still stuck? Open an issue.