Repository navigation
Receiving samples
RECEIVE gets the sample in a slot of the sampler into the app's memory, with its settings and the programs it is in. First connect the sampler.
- Choose the slot with SLOT ▲▼ on the panel. The same slot is in the MIDI view and in the SAMPLE view's SAMPLER box.
- Press RECEIVE on the panel, or RECEIVE FROM SLOT n in the SAMPLE view.
- The RECEIVE LED is lit and the display counts the seconds. Press RECEIVE again to stop. Don't close or reload the page meanwhile: the browser asks first, as the sampler's START and END are changed during the transfer.

A whole slot takes about 30 seconds over MIDI. When it is done the display says RECEIVED SLOT 1, and the sample
is in the SAMPLE view, named after its slot (SLOT 1). Type a better name in the name field above the waveform.

With RECEIVE ALL on (the default, in the MIDI view), RECEIVE:
- asks the sampler for the slot's parameters: START, END, loop, scan mode, rate, sound and key ranges
- sets START to 0 and END to the most on the sampler, because the sampler only sends from START to END
- receives all of the slot's memory
- puts START and END back as they were on the sampler, and asks again to check that they are.
The sampler is left as it was, also when the transfer fails or is stopped. The MIDI log shows each step:

The received sample gets everything the sampler had:
-
START, END and the loop where they were on the sampler. As the whole memory came over, the sample can be
longer than the part that plays:
USING 0.76S OF 0.83Sabove means START to END is 0.76 s of the 0.83 s received. What is outside START and END is shown dimmed, and is there if you want to move them later. - The scan mode (one shot, loop, alternating, drum trigger), the direction and the sample rate.
- The sound: level, filter, release and LFO, in the OUT and LFO views.
- Its key ranges in the programs it is in on the sampler. The sample goes in the same slot of the current bank, and its key ranges in the bank's programs by number, so P1 here is P1 on the sampler. See Banks and memory.
A received sample is marked FROM THE SAMPLER. It is sent back exactly as it came, bit for bit, so its audio isn't edited: no resampling, normalizing, attack or crossfade. Its points, scan mode, direction and sound can still be set. It stays marked when saved as a WAV file or in a memory file, so loading it again keeps it that way.
With RECEIVE ALL off, the sampler's START and END aren't touched, and only START to END comes over. A loop start before START is then lost: the sample plays fine on the sampler, but the part before START isn't sent.
The sample is then received as the dump has it: START to END, without the sound settings or key ranges. The log says so.
RECEIVE BANK in the BANK view receives every slot (as many as SLOTS in the MIDI view) into the current bank. See Banks and memory.
With the sampler
Without a sampler
Banks and memory
SM-87 on the M-VAVE FM-1