Skip to content

Sound OUT and LFO

Roger Klaveness edited this page Nov 8, 2026 · 3 revisions

Sound: OUT and LFO

As on the sampler, each sample has its own sound settings: level, filter, release and vibrato. Every program that plays the sample sounds the same with it. They are set in the OUT and LFO views, for the selected sample. SAMPLE at the top picks another sample, as the sampler's SAMPLE button does.

The values are 0–99, as on the sampler. The display shows what a value means (a frequency, a time, cents) next to it.

A sample received from the sampler, or loaded from a disk image, comes with the sampler's settings, and SEND sends them back. A sample dump alone doesn't carry them: the sample parameter messages do, see Connecting the sampler.

OUT

The OUT view

Parameter
LEVEL The sample's level, in steps of a third of a dB. 0 is 34 dB under 99, not silent.
VEL LEVEL How much velocity changes the level: 0 plays every note equally loud, 99 spans 40 dB from the softest note to the hardest. At 0 a note is 8 dB under the loudest the sampler plays (99 at full velocity).
FILTER A steep lowpass filter's cutoff (36 dB an octave, without resonance), from 306 Hz at 0 to 16 kHz at 99, open. It doesn't follow the key.
VEL FILTER How much velocity moves the cutoff: above velocity 64 it rises, below it falls, at 64 it is FILTER's. At 99 the velocities cover the whole range.
RELEASE How long the sound dies away after the key is let go: 17 ms at 0, 0.57 s at 50, 4.6 s at 80, 11.4 s from 90. For every scan mode but drum trigger, which plays to its end: the X7000 releases a one shot too, though its manual has it for looping sounds only.
VEL RELEASE How much the note off's velocity, how fast the key comes up, changes the release: over 64 it is shorter, under 64 longer. The on-screen and computer keyboards send 64, which leaves it as RELEASE; a MIDI keyboard that sends note off velocity changes it. The note on's velocity doesn't.

These follow measurements of an X7000, see the measurements. There is no attack setting and no filter envelope, as on the sampler. An attack can be rendered into the sample, see Editing samples.

LFO

The LFO view

The LFO adds vibrato: a sine, starting at key on. Its depth comes in 8 steps, 6.4 cents apart, up to ±47 cents.

Parameter
SPEED 1.7 Hz at 1 to 7.9 Hz at 99. 0 stops the LFO.
DEPTH How deep: none up to 12, then ±9 cents, up to ±47 from 89.
DELAY How slowly the vibrato comes in after the key goes down, a step at a time: a step every 24 ms at 0, 0.12 s at 80, 2.35 s at 99.
PRESSURE The sampler's pressure sensitivity, for MIDI channel aftertouch.

The modulation wheel adds vibrato too, at the sample's speed: a step for each sixteenth of its travel, ±47 cents at full. Channel aftertouch from a MIDI keyboard adds a step for each sixteenth of the pressure at PRESSURE 99, half as many at 50, at once, without the delay. Polyphonic aftertouch does nothing, as on the X7000. AFTERTOUCH IN shows what your keyboard sends, to check that it sends aftertouch at all. The X7000's own keyboard doesn't.

PRESSURE isn't part of the sample's parameters that SEND and RECEIVE move: on the sampler, set it in its LFO menu.

Next

Clone this wiki locally