Skip to content

HA Thread Operation tutorial

Jump to bottom
Inswift-dev edited this page Aug 12, 2025 · 2 revisions

1.Prefabrication conditions

1. The HA environment has been set up 2. The device and HA are on the same local area network

2.TCP connection operation steps

1. Download Open Thread Border Router and install the plugin image image image

2. After installation, open the plugin image

3. Perform information configuration image image image

4. Access the device backend, configure the TCP connection information of the device to HA, and then click save image image

5.Staet Open Thread Border Router image image

6. Add Thread Integration image image image

7. After adding, you can see the boundary route. If not, it may indicate that the Open Thread Border Router failed to start. Please check if the MG24 firmware is in Thread mode image image image image Note: Copy the information of the boundary routing as shown in the following figure

Clone this wiki locally