ZBM‐MG24 Router Firmware Flashing and Usage Guide

1.Firmware Acquisition

Coordinator: https://github.com/Inswift-dev/inswift-eth/tree/main/ZBM-MG24/coordinator

Router: https://github.com/Inswift-dev/inswift-eth/tree/main/ZBM-MG24/router

2.Confirm the version of the ZBM-MG24 Zigbee chip

Please carefully verify the chip version before updating the corresponding firmware. An incorrect firmware update will cause the device to fail to work properly, and it cannot be restored by re-flashing.

3. Firmware Flashing

Use any tool that supports sending Xmodem(N), Here use SecureCRT as example.

3.1 Set the "Quick Connect", and connect. The port can be viewed in the Management Console.

3.2 Dongle Enter Bootloader Mode.

Power on the device after connecting the Boot pin to GND, or restart the device after connecting the Boot pin to GND, and release the Boot button after Dongle enters the serial port Bootloader, then enter 1.

3.3 Click “Send Xmodem(N)”, select local downloaded firmware.

Note: You should complete this step before the end of the progress bar displayed as the character "C". Otherwise, an error will be reported, and you need to re-enter 1.

3.4 Download completed

3.5 Finally, enter "2" or reboot manually.

4.Usage Guide

4.1 When the device is powered on, it immediately enters the network - scanning mode. Zigbee router devices can be added via the gateway.

The router device has been added successfully:

4.2 When re-networking is required or an abnormal situation occurs, you can leave the network via the serial command "network leave" and then rejoin the network.

4.3 Enter the serial command "plugin network-steering start 1" to start network scanning.