Skip to content

Flows Actions timer_start_v2

Arie J. Godschalk edited this page Nov 15, 2026 · 1 revision

Home · Flows · Actions

Start or replace timer

What it does

Creates or replaces the named timer with the supplied start values.

Before you start

  • Use the exact type and name you want to target. A timer and another chronograph type with the same name are separate.
  • Save and enable this Flow so its name appears in related cards, device setup and widget pickers.

Arguments

Field Type How to use it
Pick autocomplete Choose or type a configured name.
Name (* BLL supported) text Used if Pick is empty; Pick wins if both are set. Accepts BLL code when Better Logic Library is installed.
Duration (* BLL supported) text Accepts BLL code when Better Logic Library is installed.
Unit dropdown Choose: seconds, minutes, hours, days

Enter a name in Name or choose one in Pick. The picker takes precedence if both are set. Names appear in suggestions after a relevant enabled Flow has been saved. * matching is supported only where noted below; it cannot be used to create a chronograph.

Output tokens

This card does not provide output tokens.

Behavior and limitations

  • Starting the same timer name replaces its active instance. Timer duration must be positive.
  • Starting the same type and name replaces the active instance. A timer requires a positive duration; a transition accepts a non-negative duration and at least two steps.

Example

Create a Flow triggered by motion, then set Name to Hall light, Duration to 2, and Unit to minutes. Expected result: the timer starts for two minutes; another run replaces its countdown.

Related pages

Full actions guide · All cards · Examples · Troubleshooting

Clone this wiki locally