Skip to content

Marine Board Display header CN4

github-actions[bot] edited this page Sep 29, 2026 · 1 revision

Home › Marine Board hardware › Marine Board

Marine Board › Display header (CN4)

Connector CN4 (JST-GH 10-pin, vertical BM10B-GHS-TBT, top side; was U10 on v1.8) for an optional small SPI display: SCK/MOSI/MISO/CS on GPIO 12/11/13/10, DC GPIO9, RST GPIO14, backlight GPIO18, plus 3.3 V, 5 V and GND. No on-board I/O protection — internal short cable only.

Marine Board › Display header (CN4)

How to get there

Connector CN4 (10-pin vertical JST-GH, below the Reset/Flash buttons)

What it does

Plug in the display's GH cable (pin 1 = +3.3 V).

Before you start

Physical access to the board; power off before plugging the cable

What you should see

Display powers from +3.3 V / +5 V with backlight on GPIO18 once firmware drives it; nothing is driven by default.

Clone this wiki locally