Skip to content

GFX9000

WacKEDmaN edited this page Oct 31, 2026 · 1 revision

GFX9000

The GFX9000 is a graphics cartridge with the Yamaha V9990 video chip, at &FF60. Fit it with Expansions → GFX9000 (V9990).

The emulator has all the V9990's screen modes (P1, P2, B0 to B7), its sprites, cursors and blitter commands. The blitter takes its real time, and the /WAIT signal stops the Z80 while the chip is busy, as on the real card.

Where its picture goes

The GFX9000 has its own video output. Video → GFX9000 monitor (or Expansions → GFX9000 monitor) chooses where it is shown:

Choice What it is
Beside the CPC screen Two monitors: its picture next to the CPC's, in the Screen window
Own window Two monitors: its picture in the GFX9000 screen window, which can go onto another display and be full screen there
One monitor (switched) One monitor: the GFX9000's picture while it shows one, the CPC's otherwise. A program gives the monitor back with OUT &FF6F,&10 and takes it with OUT &FF6F,0.
One monitor via a Video9000 A Sunrise Video9000: its genlock puts the GFX9000's picture over the CPC's, as programs set it through &FF6F and the V9990's YS bits. At power-on it shows the CPC's picture.

The GFX9000 screen window

With Own window, open Window → GFX9000 screen (the program opens it for you when you choose Own window).

  • It is a window of its own: drag it to another display.
  • F11 (while it has the focus), a double-click, or the right-click menu's Full screen on this display puts it full screen on the display it is on. Press F11 again to go back.
  • Right-click → Window: the picture x1 to x4: the window takes the picture's size at that scale, and follows the picture when the mode changes. Window: free size lets you size it yourself.

Its own display settings

The GFX9000 screen has its own scaling, CRT effect and Advanced CRT Filter. In Video settings, choose Screen → GFX9000 screen, then change the settings. Refer to Video and monitor.

The picture has the shape that the V9990's timing gives on a monitor: for example, a B1 PAL picture is a little wider than 4:3, and the 24 kHz and 31 kHz modes (B5, B6) fill a 4:3 screen. With integer scaling, each row of the picture is a whole number of screen pixels.

The GFX9000 debugger window

Tools → GFX9000 (or Window → GFX9000) shows the chip:

  • Picture: its output now.
  • Registers: all the V9990 registers, with their meanings.
  • Palette: the 64 colours.
  • VRAM image and VRAM bytes: the video memory as a picture and as bytes.
  • State: the display, the ports and the command engine (the blitter's command, its position and its progress).

Known differences

Tests on real hardware show that some blitter commands sometimes fail (a command that uses DY or NX/NY again can go wrong or stop). The emulator does not do this. The colour order of LMMV with DIX=1 is approximate.

Clone this wiki locally