Repository navigation
362 Feature: Farnsworth
Farnsworth timing sends individual characters at a faster, more natural-sounding speed while stretching out the spacing between characters and words, so the overall copying speed is slower. It's widely used for CW practice/training, since learning to recognize characters sent at a crisp, realistic speed is easier than learning them sent slowly element-by-element.
Enable it by uncommenting this line in keyer_features_and_options.h:
#define FEATURE_FARNSWORTH
Farnsworth timing in this keyer is controlled by two separate speed settings, and they are easy to mix up because of how they're named:
-
\w###(or Command ModeW, the paddle speed-adjust shortcut, the pot, etc.) sets your regular, overall sending speed - this is the slower of the two speeds, and it's the one everything else in the keyer refers to as "the" speed. -
\m###(CLI) / CTRL-M (PS2/USB keyboard) sets the character speed - the faster rate the actual dits and dahs are keyed at while Farnsworth is active.
Farnsworth timing only takes effect when the character speed (\m) is set higher than your regular speed (\w). If \m is equal to or lower than \w, Farnsworth has no effect at all - this is the single most common source of confusion: people set \m to the slow overall speed they actually want (which is what the name "Farnsworth speed" suggests you should do), see no change, and conclude the feature is broken.
\m0 explicitly disables Farnsworth.
Think of it as: \w is your target average speed, \m is how fast you want the code itself to sound. The gap between them is where the extra spacing comes from.
To send CW at a crisp 25 WPM character speed, but with the overall copying speed slowed down to 15 WPM for a learner:
\w015 (set your regular/overall speed to 15 WPM)
\m025 (set the Farnsworth character speed to 25 WPM)
Now type a message. The individual dits and dahs will sound like 25 WPM, but the gaps between letters and words will be stretched so the message takes as long overall as sending it at 15 WPM would.
To turn Farnsworth back off:
\m000
The \s (status report) command shows the current Farnsworth state:
Farnsworth WPM: Disabled
Farnsworth WPM: 25
It reports "Disabled" whenever the character speed isn't currently set higher than your regular speed (either because you set \m0, or because \w has since been raised to meet or exceed it) - not just when you've never touched \m at all.