-
Notifications
You must be signed in to change notification settings - Fork 3
Firmware Receiver v7
OneSeventyFour edited this page May 15, 2026
·
2 revisions
| Released | 2025-01 |
| Status | Historical — superseded by v8, then v9 |
| Pairs with dongle | v3+ |
| Predecessor | v6 |
| Notable | Migrated off RF24Mesh — direct point-to-point addressing. |
| File | Purpose | Download |
|---|---|---|
os4_receiver_v7.bin |
App partition. | Download |
os4_receiver_v7.bootloader.bin |
Chip bootloader. | Download |
os4_receiver_v7.partitions.bin |
Partition table. | Download |
os4_receiver_v7.boot_app0.bin |
OTA "next-app" pointer. | Download |
Migrated from RF24Mesh to pure RF24 with deterministic addressing. Removed the mesh routing overhead — the direct nRF24L01+PA+LNA range (1000+ yards) made mesh unnecessary, and the routing layer's failure modes were complicating debugging.
- Hard wire-protocol break with v6 and earlier. Pair with dongle FW v3+.
- Run a coordinated fleet upgrade.
- Wired only. Flashing a receiver.
Getting started
- Overview
- Desktop installers (macOS / Windows)
- macOS
- Linux
- Windows
- Production vs Development
- Connecting the dongle
- Flash a receiver
- Flash a dongle
- OTA flashing
Raspberry Pi
System overview
Subsystems
Hardware
- Receiver firmware
- Dongle firmware
- RF protocol
- Contributor Portal — BOMs, schematics, and board resources
UI walkthrough
Reference
Downloads
- Firmware
- Installers
Module Build & User Guides
- Cue
- Receiver
- Dongle